3D Printer - 3DS Cube no.1

From The Maker Station Wiki!
Revision as of 17:23, 8 October 2014 by Tanju (talk | contribs)
Jump to: navigation, search

Back to list of Equipment


  • Owner/Loaner: TJ Bayramoglu
  • Serial Number: Serial Number?
  • Make/Model: Cube 2nd gen
  • Arrival Date: Oct 5, 2014
  • Usability: {{{usagerestrictions}}}
  • Contact: TJ Bayramoglu
  • Where: 3D printer station


Info

File:Example.jpg

The Cube2 by 3D Systems is an entry level printer targeted to the mass consumer market. It is intended to be easy to use with minimal effort, that means limited settings to fine tune more complex prints. Nevertheless it is a good printer to start with.

General Specs Material: PLA (OEM filament cartridges) Build Dimensions: 140mm x 140mm x 140mm Layer Height: 0.2 mm or 200 microns

Permissions

For general use by members. Treat equipment as if it were your own and put away as or better than you found it.

Restrictions

  • Use with 1.75 mm PLA OEM filament only.
  • The printer and cartridges have proprietary encrypted chips and the printer won't work with non-OEM filaments. Using non-OEM filament will also result in nozzle jams... so don't try it.
  • Initial training required to use the printer, contact a knowledgeable MakerStation member for intial training.